2011-2012 BMW 3-serie E90 E91 E92 E93-335i N55 motorudstødningsnedløbsrør
$251.77
SKU: C138-B060~003
Gratis og hurtig levering
Sikker og pålidelig handel
Funktion:
BMW 335i-nedløbsrøret er fremstillet af T304 rustfrit stål af høj kvalitet og er TIG-svejset internt.
Decat'en er fremstillet i Storbritannien, og flangerne er laserskåret mellem 10-12 mm.
Skarpere gasrespons på grund af hurtigere turboomdrejninger
Mærkbar effektforøgelse og en meget mere aggressiv udstødningstone, der lyder virkelig fantastisk
Giver lavere temperaturer og mindre udstødningsmodtryk på grund af aflastningen af turboladeren. Cylinderfyldningen øges også.
Der er også en betydelig vægtbesparelse i forhold til den fabriksmonterede katalysator
Dornbøjet for bedre gasflow og maksimal indvendig størrelse for at sikre ultimativ ydeevne uden tab af drejningsmoment i mellemområdet.
Specifikationer:
Stand: 100% helt ny
Materialetype: Rustfrit stål
Montering:
Til BMW 1-serie E82 E88-135i N55 Motor 2011-2012
Til BMW 3-serie E90 E91 E92 E93-335i N55 Motor 2011-2012
Pakken indeholder:
1x Rør
2x pakninger
5x skruer
Forsendelsesoplysninger:
Leveringstid: 3-8 hverdage.
Gratis hurtig levering fra Californien.
Customer Reviews
2012-2018 Audi A6 C7/C7.5 A7 C7/C7.5 3.0T V6 Exhaust Racing Downpipes
Sounds alright make sure you have afm disabled, makes it deeper and more enjoyable but not as loud as you think it will make it. If you want loud you’ll have to do the resonator further back as well, as well as an issue of the pipe not being long enough to cut the flapper out so that’s another restriction. I welded mine open. Fit well after the muffler but the inlet pipe is a little smaller causing you to have to really tighten the exhaust clamp down to get it tight. Does not completely seal so there will be a slight leak around the edges unless you fix that with some welds or exhaust wrap/tape. But for 80 bucks it’s a good deal and the easiest way to diy it the right way.
This will take you about 20min to install. Super simple. YouTube has a great video step by step. Instructions that come with it you can't even read so don't try. Muffler shop will charge you about $150-$200 so this is much better option and if you trucks lifted it's even better.
Actually works!
Wasn’t a direct fit, but worked well with some tweaking. Also had to trim about 8” out of the middle section (comes with three sections) to meet length. One of the bends was slightly off for factory exhaust tips to align in bumper, but for the money it was fine.